LessStress Premium

General hints

Every drilled job with LessStress follows the same protocol: the two coordinates of a hole refer to a reference point of the Y-axis at 0.00 and the edge of the lens. You will measure holes and notches starting from this point.

You can find a detailed manual with further instructions at Downloads.

The angle in which the lenses should be drilled are determined by the frame chassis/mounting. If you drill plus or minus lenses - the adjustment of the mounting will be a lot easier if you do not drill vertically but use the angles given by the frame chassis/mounting. If you are not sure about the angle, using an angle of 8° will be close to the optimal angle (drawing 1 and 2).

Drill konkav

drill konvex

Seite: 0  1  2  3  4  5 6  7  8  9  10  11  12  13  14  15  16